Figure 30. Location of motor brush wires.
Figure 33. Motor brushes installed.
Figure 34. Motor brush wire routing position.
Figure 31. Disconnecting motor brush wires.
Figure 32. Removing brush from holder.
Model T33300 (Mfd. Since 04/22)
-29-
4. Lift cover off motor to access brush wires
(see
Figure 30).
6. Using a flat head screwdriver, carefully posi-
tion screwdriver shaft under brush spring and
brace against both screw posts. Lift brush
spring straight up and gently pull brush wire
to slide brush out of holder (see
Figure 32).
5. Use needle-nose pliers to disconnect brush
wires from motor wires by carefully pulling
apart terminal connectors (see
Figure 31).
IMPORTANT: DO NOT pull on wires!
Only Grasp Here When
Disconnecting Terminals
7. Install replacement brushes in holders with
wire-side down, and move brush springs
back to their original position against brushes
(see
Figure 33).
8. Connect replacement brush wires to motor
wires.
9. Route motor wires through wire routing posi-
tions (see
Figure 34).
Note: Proper wire routing helps prevent
motor wires from contacting spinning motor
components during operation.
10. Re-install motor cover and secure with (4)
motor cover screws removed in
Step 3 on
Page 28.
11. Proceed to Test Run on Page 15.
Brush Wires
Motor
Wire
Brush
Wire
Brush Spring
Screw Post
(1 of 2)
Brush
Spring
Wire Routing
Position (1 of 2)
Motor Wire
Summary of Contents for T33300
Page 36: ......
