Grizzly T33300, Owner'S Manual

Page: 18 / 36

The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-16-
Model T33300 (Mfd. Since 04/22)
SECTION 4: OPERATIONS
To complete a typical operation, the operator
does the following:
1. Examines workpiece to make sure it is suit-
able for cutting, and selects appropriate
blade for material being cut.
2. Aligns riving knife with blade, and positions
riving knife correct distance away from blade.
3. Adjusts blade tilt, if necessary, to correct
angle of desired cut.
4. Adjusts blade height approximately
1 ⁄
8
"
beyond bottom of workpiece.
5. Puts on safety glasses and a respirator.
6. Positions front of saw on workpiece, leav-
ing enough room for blade to fully extend
from bottom without coming into contact with
workpiece.
7. Engages plunge release and extends blade.
8. Activates saw by pulling ON/OFF trigger
while holding plunge release.
9. Moves saw forward over workpiece in an
even, steady motion.
10. Releases ON/OFF trigger and allows blade to
come to a complete stop.
11. Returns saw to upright position by lifting up
on handle, allowing blade to retract and lock
in place.
Operation Overview