Grizzly G3616, Owner'S Manual

Page: 11 / 72

G3616/G3617 Mill 9
The information contained herein is deemed accurate as of 10/1/2007 and represents our most recent product specifications.
Due to our ongoing improvement efforts, this information may not accurately describe items previously purchased.
PAGE 2 OF 3 Model G3617
Coolant
Type...................................................................................................................................................AC Sealed
Horsepower..............................................................................................................................................1/8 HP
Voltage.................................................................................................................................................110/220V
Prewired......................................................................................................................................................220V
Phase........................................................................................................................................................Single
Amps....................................................................................................................................................0.9/0.45A
Cycle..........................................................................................................................................................60 Hz
Number Of Speeds........................................................................................................................................... 1
Power Transfer ................................................................................................................................Direct Drive
Bearings........................................................................................................ Shielded, Permanently Lubricated
Main Specifications:
Operation Info
Spindle Travel.............................................................................................................................................. 5 in.
Swing..........................................................................................................................................................54 in.
Longitudinal Table Travel........................................................................................................................... 22 in.
Cross Table Travel.................................................................................................................................8-1/2 in.
Vert. Table Travel.......................................................................................................................................13 in.
Table Swivel.................................................................................................................... Left and Right 45 deg.
Knee Travel................................................................................................................................................ 13 in.
Ram Travel.................................................................................................................................................11 in.
Ram Swivel Angle................................................................................................................................... 90 deg.
Head Travel..................................................................................................................................................5 in.
Head Swivel............................................................................................................................................ 90 deg.
Head Tilt.......................................................................................................................... Left and Right 90 deg.
Turret Or Column Swivel................................................................................................. Left and Right 90 deg.
Max. Dist Spindle To Column.....................................................................................................................27 in.
Max. Dist Spindle To Table.................................................................................................................. 13-3/4 in.
Drilling Cap For Cast Iron.......................................................................................................................1-1/4 in.
Drilling Cap For Steel............................................................................................................................. 1-1/4 in.
Max. Dist Horz. Spindle Center To Table.............................................................................................11-3/8 in.
No. Of Vert. Spindle Speeds............................................................................................................................. 9
Range Of Vert. Spindle Speeds..................................... 270, 390, 490, 615, 860, 930, 1600, 1960, 2950 RPM
No. Of Horz. Spindle Speeds............................................................................................................................ 8
Range Of Horz. Spindle Speeds.................................................. 72, 170, 210, 240, 290, 550, 830, 1300 RPM
No. Of Longitudinal Feeds..................................................................................................................... Variable
Feed Rate....................................................................................................................................... 0 - 140 RPM
Quill Dia..................................................................................................................................................3-1/2 in.
Table Info
Table Length........................................................................................................................................ 39-3/8 in.
Table Width............................................................................................................................................ 9-1/2 in.
Table Thickness..................................................................................................................................... 2-1/2 in.
No. Of T Slots....................................................................................................................................................3
T Slots Width......................................................................................................................................... 0.640 in.
T Slots Height...............................................................................................................................................1 in.
T Slots Centers.............................................................................................................................................3 in.
Stud Size...................................................................................................................................................1/2 in.
Lead Screw Info
Lead Screw Diameter...................................................................................................................................1 in.
Lead Screw TPI.................................................................................................................................................5
Lead Screw Length.................................................................................................................................... 43 in.