Grizzly G3616, Owner'S Manual

Page: 30 / 72

28 G3616/G3617 Mill
The mill table can be rotated 45º in either direction
for positioning the workpiece.
To rotate the mill table:
1. Make sure the power is turned OFF .
2. Remove as many items from the mill table
as possible. This will make rotating the table
easier.
3. Loosen four nuts, two in front and two in back,
to free the table for rotation (see
Figures 25
& 26 ).
Figure 26. Rear table nuts.
The Model G3616/G3617 comes equipped with
a milling vise. The vise has a swivel base that
allows it to rotate 360º.
To rotate the vise:
1.
Make sure the power is turned
OFF
.
2.
Loosen the vise nuts (see
Figure 27
), one on
each side, to free up the vise.
Vise Rotation
Table Rotation
Figure 25. Front two table nuts.
Table Nuts
4.
Rotate table to desired position. There is a
graduated scale to use when setting the posi-
tion.
5.
Tighten the four nuts to secure the table in
position.
Table Nuts
Figure 27.
Vise nuts (1 of 2 shown).
Vise Nut
3.
Rotate the vise to the desired position. The
swivel base has graduations for more accu-
rate positioning.
4.
Tighten the two nuts to lock the vise in
place.
Graduated Scale