Grizzly G0923, Owner'S Manual

Page: 27 / 56

Model G0923 (Mfd. Since 05/20)
-25-
Figure 24. Paper used to measure leveling
adjustments.
Note: There should be noticeable resistance,
but paper should not be difficult to move.
5. Remove paper and press control dial. Nozzle
will move to next corner.
6. Repeat Steps 4–5 until each corner has been
leveled. Axes will home.
7. Repeat Steps 1–5 and check that nozzle
height remains equal across all four points.
— If distance between nozzle and build plate
is equal across all four points, the leveling
process is complete.
— If distance between nozzle and build plate
is NOT equal across all four points, repeat
the leveling process.
4. Slide paper under nozzle (see Figure 24).
Adjust wing nut under nozzle until nozzle
barely touches paper.
Paper
Wing Nut
(1 of 4)
Tools Needed Qty
Sheet of Paper .................................................. 1
To level build plate:
1. Navigate to "Auto Home" from main menu.
Wait for axes to home.
2. Move axes so nozzle is over front-left corner
of build plate. For more information, refer to
Moving Axes on Page 30.
3. Slide paper under nozzle (see Figure 25).
Adjust wing nut under nozzle until nozzle
barely touches paper.
Note: There should be noticeable resistance,
but paper should not be difficult to move.
4. Remove paper and repeat Steps 2–3 for
each corner of build plate.
5. Move axes so nozzle passes over each
corner of build plate and check that nozzle
height remains equal.
— If distance between nozzle and build plate
is equal across entire build plate, the level-
ing process is complete.
— If distance between nozzle and build plate
is NOT equal across entire build plate,
repeat the leveling process.
Manual Leveling
Figure 25. Paper used to measure leveling
adjustments.
Nozzle
Nozzle
Paper
Wing Nut
(1 of 4)