Model G0900 (Mfd. Since 03/20)
-43-
Figure 62. Spindle slide and leadscrew location.
Leadscrew
Slide
Since all bearings on the G0900 are sealed and
permanently lubricated, simply leave them until
they need to be replaced. DO NOT lubricate them.
Below is a list of components that require periodic
lubrication. Do not over-lubricate these compo-
nents. Large amounts of lubricant will attract
sawdust, causing the metal components to gum
up and bind.
Lubrication
1. DISCONNECT MACHINE FROM POWER!
2. Unlock guard and fence assembly from table
by loosening lock knobs pictured below in
Figure 63.
Figure 63. Fence rack and assembly location.
Rack
Fence Assembly
Adjustment Knob
Fence/Guard Assembly
Lock Knobs (1 of 2)
5. Apply a thin coat of lubricant to slides and
leadscrew.
6. Use handwheel to fully raise and lower
spindle housing to distribute grease.
1. DISCONNECT MACHINE FROM POWER!
2. Lower spindle housing assembly fully by
turning handwheel counterclockwise.
3. Use rag and mineral spirits to clean away
grease and built up grime from surfaces of
both slides and threads of leadscrew (see
Figure 62).
Items Needed
Qty
Hex Wrench 4mm .............................................. 1
Mineral Spirits .................................... As Needed
Shop Rags ......................................... As Needed
Lubrication Type ... T26419 or NLGI#2 Equivalent
—Amount..............................................Thin Coat
—Frequency ...................................... As Needed
Elevation Leadscrew & Spindle Slides
Fence Rack & Pinion
T26419—Syn-O-Gen Synthetic Grease
Figure 61. T26419 Syn-O-Gen Synthetic
Grease.
4. Use rag and mineral spirits to clean away
grease and built up grime from surfaces of
both slides and threads of leadscrew (see
Figure 62).
Lubrication Steps
Summary of Contents for G0900
Page 68: ......
