-16-
Model G0888 (Mfd. Since 01/19)
7. Attach work light to support, as shown in
Figure 10, using (4)
1
⁄
4
"-20 x
3
⁄
4
" hex bolts and
(4)
1
⁄
4
" flat washers.
Note: Position of work light can be adjusted
by loosening thumb screws on each mount-
ing clamp, moving work light side to side or
rotating it front to back, and then retightening
thumb screws.
8. Use (3) included 6" cable ties to secure work
light power cord (see
Figure 10) to work light
support.
9. Attach (2) dust hoses to dust inlets and secure
with (2) 2
1
⁄
2
" hose clamps (see
Figure 11).
10. Remove (4) pre-installed hex bolts and flat
washers from (4) rubber feet (see
Figure 12).
11. Position grinder mounting plate (see Figure
12) on top of rubber feet, and secure with hex
bolts and washers removed in
Step 10.
12. Place coolant cups in rubber holders in front
of mounting plate (see
Figure 12).
Figure 10. Work light mounted to support.
Support
Work Light
Power
Cord
Thumb
Screws
(1 of 2)
Figure 11. Dust hoses attached to dust inlets.
Hose
Clamp
Dust
Hose
Figure 12. Grinder mounting plate installed.
Rubber
Feet
(2 of 4)
Grinder
Mounting Plate
Hex Bolts
w/Washers
(1 of 4)
x 4
Summary of Contents for G0888
Page 15: ...Model G0888 Mfd Since 01 19 13 5mm Hardware Recognition Chart ...
Page 36: ......