Model G0860/G0861/G0862 (Mfd. Since 10/18)
-27-
To test run machine:
1. Clear all setup tools away from machine.
2. Lock all swivel casters on base stand.
3. To limit motor amperage draw, connect
machine to dust-collection system and restrict
air flow into dust collector.
IMPORTANT: DO NOT operate the dust
collector without restricting air flow. The
machine will quickly reach full amperage
load and can trip a circuit breaker. If a dust-
collection system is not available, restrict air
flow by blocking an inlet adapter port with one
of the included 4" lids.
4. Press Emergency Stop button in.
5. Connect machine to power.
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
6. Twist Emergency Stop button clockwise until
it springs out (see
Figure 32). This resets the
switch so the machine can start.
7. Standing away from intake port, press green
"I" button to turn machine
ON. Verify motor
starts up and runs smoothly without any prob-
lems or unusual noises.
8. Press Emergency Stop button to turn machine
OFF.
9. WITHOUT resetting Emergency Stop button,
try to start machine by pressing the "I" button.
The machine should NOT start.
— If the machine does not start, the Emergency
Stop button is working correctly.
— If the machine does start, immediately
turn it
OFF and disconnect power. The
Emergency Stop button is NOT working
properly and must be corrected before
further using the machine.
10. To test remote control operation, press green
remote button to turn motor
ON. The motor
should run smoothly with little or no vibration
or rubbing noises.
11. Press red remote button to turn motor OFF.
— If the machine does not shut off with
the remote control, press the Emergency
Stop button to turn machine
OFF. Refer
to Troubleshooting on
Page 42 to cor-
rect any problems with the remote control
unit before further using it again with the
machine.
Figure 32. Resetting Emergency Stop button.