Model G0845P (Mfd. Since 01/18)
-27-
To cut a workpiece:
1. Measure workpiece for thickness and mark
for length of cut.
2. Set blade gap adjusters equally to
match workpiece material thickness (see
Figure 30).
IMPORTANT: DO NOT exceed maximum
blade gap measurements listed on adjusters.
Figure 30. Measure workpiece, then set both
blade gap adjusters according to chart.
0
0.010
Stainless Steel
Mild Steel
Aluminum/
Copper
Blade
Gap (in.)
Sheet Thickness (in.)
0.125
0.100
0.075
0.050
0.025
0.015
0.005
Material
0.150
0.017
4. Square workpiece against left work stop, then
push workpiece against rear work stop, as
shown in
Figure 32.
Figure 31. Rear work stop assembly features.
Lock Handle
Magnifier Scale
3. Use scale and magnifier on rear work stop
assembly to set workpiece depth of cut (see
Figure 31), then tighten lock handles.
Figure 32. Properly placing workpiece against
left work stop and rear work stop for cut.
Rear Work Stop
Left Work Stop
Blade Gap
Adjuster (1 of 2)
Summary of Contents for G0845P
Page 68: ......
