Model G0836 (Mfd. Since 09/17)
-21-
8. Watch for table limit stop to hit limit switch
(see
Figure 19). When it hits, FAULT indicator
should illuminate orange (see
Figure 18) and
motor should stop. If power feed DOES NOT
stop, turn speed control dial
OFF and move
direction switch to middle (OFF) position.
9. Turn speed control dial OFF to correct FAULT
mode.
10. Flip direction switch through neutral (middle)
position and all the way to the right. Turn
speed control dial clockwise to turn power
feed
ON. Table should begin moving to the
right.
11. Confirm that table stops moving when table
limit stop presses against limit switch.
12. Move direction switch to neutral (middle)
position and turn speed control dial to
OFF.
Congratulations! The
Test Run of the mill is com-
plete. Continue to the next page to perform the
Spindle Bearing Break-In and Inspections &
Adjustments procedures.
To test run power feed:
1. Make sure all tools, cables, and other items
are well clear of table movement and potential
direction of travel.
3. Loosen X-axis table lock on front of table
(see
Figure 19).
4. Turn leadscrew selector knob (Figure 19)
clockwise to engage power feed drive gear.
5. Turn speed control dial all the way counter-
clockwise to prevent high-speed startup.
6. Move direction switch to left position.
7. Turn speed control dial clockwise to turn
power feed
ON, then gradually increase
speed to confirm that table is moving to left.
During power feed opera-
tion, X-axis handwheel
handle will spin rapidly if
it is pressed in or acciden-
tally engaged. Always stay
clear of handle when using
power feed. Failure to do so
could lead to entanglement
or impact injuries.
2. Read Controlling Table Travel section,
beginning on
Page 26, to understand function
of power feed, table locks, and limit stops.
Summary of Contents for G0836
Page 60: ......
