Grizzly G0836, Owner'S Manual

Page: 38 / 60

-36-
Model G0836 (Mfd. Since 09/17)
Table and Column Ways
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ........8 Hours of Operation
Regular lubrication will ensure mill/drill performs
at its highest potential.
Remove column way cover
and regularly wipe X-, Y-, and Z-axis ways with
recommended lubrication, then move compo-
nents back and forth several times over full range
of travel to spread lubricant and ensure smooth
movements (see
Figures 57–59).
Figure 59. X-axis way lubrication points.
X-Axis Ways
Figure 61. Location of X-axis leadscrew.
X-Axis Leadscrew
Table Leadscrews
Lube Type ............. SB1365 or ISO 68 Equivalent
Lube Amount ........................................Thin Coat
Lubrication Frequency ......40 Hours of Operation
To lubricate table leadscrews:
1. DISCONNECT MACHINE FROM POWER!
2. Using Y-axis handwheel, move table as far
forward as possible and remove way cover.
3. Use mineral spirits and brush to clean Y-axis
leadscrew shown in
Figure 60. Allow to dry.
4. Apply oil to exposed leadscrew threads, then
move table through full range of cross motion
several times to disperse oil along leadscrew.
5. Replace way cover.
6. Using X-axis handwheel or power feeder,
move table as far to one side as possible.
7. Repeat Step 3 for X-axis leadscrew
(see
Figure 61).
8. Repeat Step 4.
Figure 60.
Location of Y-axis leadscrew.
Y-Axis
Leadscrew
Way
Cover
Figure 58. Y-axis way lubrication points.
Y-Axis Ways
Figure 57. Z-axis way lubrication points.
Z-Axis
Ways