Grizzly G0832, Owner'S Manual

Page: 6 / 52

-4-
Model G0832 (Mfd. Since 04/17)
Controls &
Components
Refer to
Figures 1–3 and the following descrip-
tions to become familiar with the basic controls of
this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
A. ON/OFF Switch: Turns motor ON when
flipped up; turns motor
OFF when pressed
down.
B. ON/OFF Switch Disabling Key: Disables
switch when yellow key is removed to prevent
unauthorized operation of planer.
C. Reset Button: Allows machine to be restarted
after thermal overload protection has tripped.
To reset, place ON/OFF switch in OFF posi-
tion, wait a few minutes for motor to cool,
then press reset button. If button does not
stay depressed, allow motor to cool longer,
then try again.
D. Depth-of-Cut Gauge: Shows depth of cut
(from 0"–
1
⁄
8
") when workpiece contacts
indicator at bottom of gauge.
E. Cutterhead Elevation Crank: Raises and
lowers cutterhead. Rotate clockwise to raise
cutterhead; rotate counterclockwise to lower
it. Each full rotation changes elevation
1
⁄
16
".
F. Return Rollers: Assist sliding workpiece
back to operator following planing operation.
G. Cutterhead Lock Lever: Locks cutterhead
height in place. In upward position, cutterhead
lock is released so headstock height can be
adjusted. Used to ensure cutterhed doesn't
move during operation.
Figure 1. ON/OFF switch and reset button.
C
Figure 2. Elevation controls and return rollers.
F E
A
B
H. Cutterhead Elevation Scale: Shows eleva-
tion of cutterhead above table. The measure-
ment indicated along top edge of red indica-
tor shows effective thickness of board after
planing.
I. Cutterhead Depth Stop Dial: Quickly adjusts
headstock height from
1
⁄
8
"–1
1
⁄
4
" per factory
detents.
Figure 3. Depth stop dial and elevation scale.
H
I
D
G