Model G0832 (Mfd. Since 04/17)
-39-
Replacing Table
Height Chain
The table height chain transfers movement from
the elevation handwheel to the leadscrews that
control cutterhead height. Replace the chain drive
if the chain stretches over time or breaks.
Tools Needed
Qty
Needle Nose Pliers ............................................ 1
Hex Wrench 6mm .............................................. 1
To replace table height chain:
1. DISCONNECT MACHINE FROM POWER!
2. Gently tilt machine onto its side to expose
table height chain (see
Figure 46) and
sprokets.
3. Locate chain connection clasp and remove
cotter pin to disconnect chain (see
Figure 46).
4. Clean and lubricate new chain and leadscrew
sprockets (refer to
Table Height Chain
& Sprockets on Page 29 for detailed
instructions).
5. Install chain around sprockets, and connect
chain with cotter pin.
Figure 46. Table height chain.
Cotter Pin
Summary of Contents for G0832
Page 52: ......
