Model G0821 (Mfd. Since 03/18)
-39-
To replace fan belt:
1. DISCONNECT MACHINE FROM POWER!
2. Remove motor cover and check belt for
damage.
— If belt shows no wear or damage, proceed
to
Step 4.
3. Loosen (2) cap screws from fan mount. DO
NOT remove screws!
4. Shift fan assembly to remove fan belt. Put
one end of new belt on fan pulley, then fit
other end onto the drive pulley.
Note: If belt is misaligned, the jointer needs
to be serviced by a qualified technician. Call
our Tech Support.
5. Re-install motor cover.
Figure 57. Motor fan belt location (cover
removed).
Motor Mount Screws
Cutterhead Belt
Fan Belt
Adjusting Infeed
Table Parallelism
The infeed and outfeed tables must be parallel
with each other in order to produce a straight
jointed edge. When the tables are not parallel with
each other, the jointer will produce workpieces
that are cupped (concave) or bowed (convex)
along their length.
Table parallelism is factory-set and should not
need to be adjusted when the machine is new.
However, after prolonged use, or if the machine
has been jarred during lifting or transportation,
it may become necessary to adjust the table
parallelism.
The G0821 uses set screws to adjust infeed table
height. The outfeed table and cutterhead assem-
bly have been properly aligned at the factory and
do not require adjustment.
Tools Needed
Qty
Phillips Head Screwdriver #2 ............................ 1
Precision Straightedge 36" ................................ 1
Hex Wrench 3mm .............................................. 1
Hex Wrench 5mm .............................................. 1
Hex Wrench 6mm .............................................. 1
To adjust infeed table parallelism:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cutterhead guard and fence
assembly.
Summary of Contents for G0821
Page 52: ......
