Grizzly G0821, Owner'S Manual

Page: 25 / 52

Model G0821 (Mfd. Since 03/18)
-23-
Setting Depth of Cut
The depth of cut on a jointer affects the amount
of material removed from the bottom of the
workpiece as it passes over the cutterhead.
The depth of cut is set by adjusting the height of
the infeed table relative to the cutterhead inserts
at TDC (top dead center) and the outfeed table.
Adjusting Zero Stop
The zero stop (see
Figure 23) allows the operator
to consistently bring the infeed table even with the
outfeed table height.
Adjusting Infeed Table Height
Figure 22. Location of infeed table adjustment
knob.
Infeed Table
Adjustment
Knob
To adjust infeed table height, rotate the infeed
table adjustment knob to raise or lower the table
(see
Figure 22).
Tools Needed Qty
Precision Straightedge 24" ................................ 1
Hex Wrench 3mm .............................................. 1
Open-End Wrench 10mm .................................. 1
Figure 23. Zero stop components.
Tension
Hex Nut
Zero Stop
Set Screw
Infeed Table
Adjustment Knob
To set zero stop:
1. Place a straightedge on top of outfeed table
and use infeed table adjustment knob to raise
or lower table until table contact is even along
straightedge.
Figure 24. Checking table parallelism.
Straightedge
Outfeed Table
Infeed Table
2. Loosen tension hex nut, and adjust zero stop
set screw until it contacts table base (see
Figure 23).
3. Tighten tension hex nut to secure height
setting.