-38-
Model G0809 (Mfd. Since 1/17)
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Figure 44. Recommended products for
protecting unpainted cast-iron and steel.
G5562—SLIPIT® 1 Qt. Gel
G5563—SLIPIT® 12 Oz. Spray
G2871—Boeshield® T-9 12 Oz. Spray
G2870—Boeshield® T-9 4 Oz. Spray
H3788—G96® Gun Treatment 12 Oz. Spray
H3789—G96® Gun Treatment 4.5 Oz. Spray
Protect the unpainted cast iron surfaces on the
table by wiping the table clean after every use—
this ensures moisture from wood dust does not
remain on bare metal surfaces.
Keep tables rust-free with regular applications of
products like G96
®
Gun Treatment, SLIPIT
®
, or
Boeshield
®
T-9.
Cleaning &
Protecting
The cleaning process for this machine is simple.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin dissolving cleaner
to remove it. Treat all unpainted cast iron and steel
with a non-staining lubricant after cleaning.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily (or More Frequently as Needed)
•
Vacuum all dust on and around the machine.
•
Wipe down tables and all other unpainted
cast-iron with a metal protectant.
•
Check for/repair worn or damaged wires.
•
Check/replace damaged cutterhead or blades
(
Page 47).
•
Check/retighten loose mounting bolts.
•
Check/resolve any other unsafe condition.
Monthly (or More Frequently as Needed)
•
Belt tension, damage, or wear (
Page 43).
•
Clean/vacuum dust buildup from inside stand
and off of motor.
Schedule
Lubrication
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth moving components.
Clean the components below with mineral spirits
or other oil/grease solvent cleaner and shop rags.
Summary of Contents for G0809
Page 72: ......
