Grizzly G0808, Owner'S Manual

Page: 33 / 68

Model G0808 (Mfd. Since 11/15)
-31-
Removing Tooling
Spindle Downfeed
Spindle downfeed movement on the drill press
is controlled by two mechanisms: 1) The coarse
downfeed lever, and 2) the fine downfeed
handwheel (see
Figure 46). Refer to Controls &
Components on Page 4 for detailed descriptions
of all downfeed controls and components.
Using Coarse Downfeed
Coarse downfeed is typically used for drilling,
because it allows you to quickly lower the spindle
with varying speed/pressure, and it automatically
retracts the spindle back to the top position when
released.
To engage coarse downfeed, make sure the
spindle is completely stopped, and loosen the
downfeed selector knob (see
Figure 46).
Note: To maintain control of the upward spin-
dle travel, always continue holding the coarse
downfeed levers until the spindle returns to the
top position. Letting go of the levers too soon will
cause the spindle to retract too quickly and slam
up into the headstock.
Downfeed
Selector
Knob
Coarse
Downfeed
Levers
Figure 46. Downfeed controls.
Graduated
Dial
Quill
Lock Lever
Fine Downfeed
Handwheel
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Set spindle speed range lever to "L" to pre-
vent spindle rotation during next step.
3. Remove motor cover.
4. Unthread drawbar from tool one full rotation.
Note: Make sure that drawbar has at least
three threads engaged with tooling, or
drawbar and tool threads could be damaged
during next step.
5. Tap top of drawbar with brass-head or dead-
blow hammer to unseat taper (see Figure 45).
Figure 45. Tapping drawbar to unseat tool taper.
6. Support tool with one hand and fully unthread
drawbar from tool.
Tools Needed Qty
Hex Wrench 3mm .............................................. 1
Wrench or Socket 17mm ................................... 1
Brass-Head or Dead-Blow Hammer .................. 1