Model G0808 (Mfd. Since 11/15)
-27-
Graduated Collars
The table handwheels have graduated collars
(see
Figure 35) that are used to determine table
movement in 0.001" increments with one full revo-
lution equaling 0.100" of travel.
Additionally, each collar has a thumbscrew that is
used to adjust the dial to "0".
Figure 35. Locations of graduated collars.
Graduated
Collars
Always keep table locked in place unless
table movement is required. Unexpected
table and workpiece movement could cause
tooling to bind with workpiece, which may
damage tooling or workpiece.
Table Locks
Use table locks to increase the rigidity of the table
when movement in that axis is not required for the
operation.
Refer to
Figure 36 to identify the locks for each
table axis.
Figure 36. Location of table locks.
X-Axis Locks
Y-Axis
Locks
Z-Axis
Lock
Master Power Switch
The Master Power Switch (see
Figure 33) toggles
the incoming power
ON and OFF. It can be locked
in the OFF ("0") position to prevent unauthorized
use.
To lock the switch in the
OFF position, rotate the
switch to the
OFF position, press the locking tab
in, then insert a padlock with a maximum shank
diameter of
3
⁄
16
" through the hole in the tab and
switch body (see
Figure 33).
Figure 33. Master power switch.
Master Power
Switch
Table Movement
The table travels in three directions (see
Figure 34).
This travel is controlled by table handwheels and
the Z-axis crank handle. Additionally, the table
can be moved along the X- and Z-axis with the
power feed and manually rotated 360° around the
column.
X-Axis or Longitudinal Travel
(Left & Right)
Y-Axis or
Cross Travel
(In & Out)
Z-Axis or
Vertical Elevation
(Up & Down)
Figure 34. The directions of table movement.
Locking Tab
with
3
⁄
16
" Hole
Summary of Contents for G0808
Page 68: ......
