Model G0808 (Mfd. Since 11/15)
-23-
9. Press green ON button to turn machine ON.
10. Move spindle direction switch to the right,
and then slowly rotate spindle speed dial to
"1". Verify motor starts up and runs smoothly
without any unusual problems or noises.
11. Press Emergency Stop button to turn machine
OFF.
12. WITHOUT resetting Emergency Stop button,
try to start machine by pressing the ON but-
ton. The machine should not start.
— If the machine does not start, the safety
feature of the Emergency Stop button is
working correctly. Congratulations! The
Test Run is complete.
— If the machine does start, immediately
turn it
OFF and disconnect power. The
safety feature of the Emergency Stop but-
ton is NOT working properly and must be
replaced before further using the machine.
Figure 32. Resetting the switch.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Refer to
Figures 30–31 for the locations of the
various controls necessary for performing the
Test Run.
Figure 30. Master Power Switch in OFF ("0")
position.
Master Power
Switch
Figure 31. Location of controls necessary for
Test Run.
Spindle
Direction
Switch
ON & OFF
Buttons
To test run machine:
1. Clear all setup tools away from machine.
2. Rotate Master Power Switch to ON ("1")
position.
Emergency Stop/
Reset Button
Spindle
Speed Dial
Spindle Speed
Range Lever
3. Press Emergency Stop/Reset button.
4. Move spindle direction switch to neutral
(middle) position.
5. Rotate spindle speed dial to "0".
6. Move spindle speed range lever to "L".
7. Connect machine to power by inserting power
cord plug into a matching receptacle. Digital
readout and ON/OFF buttons will illuminate.
8. Twist Emergency Stop button clockwise until
it springs out (see
Figure 32). This resets
switch so machine can start.
Summary of Contents for G0808
Page 68: ......
