Grizzly G0803, Owner'S Manual, Page: 15 / 60

G0803 (Mfd. Since 09/15)
-13-
SECTION 3: SETUP
Inventory
Needed for Setup
Inventory (Figure 6) Qty
A. Table/Trunnion Assembly ........................... 1
B. Push Stick .................................................. 1
C. Miter Gauge Assembly ............................... 1
D. Fence.......................................................... 1
E. Fence Rail Knobs M6-1 x 16 ...................... 2
F. Fence Rail Knob M6-1 x 24 ........................ 1
G. "D" Nut M6-1 .............................................. 1
H. Fence Rail .................................................. 1
I. Bandsaw Body (not shown) ........................ 1
J. Rubber Feet (not shown) ............................ 4
Your machine was carefully packaged for safe
transportation. Remove the packaging materials
from around your machine and inspect it. If you
discover any damage, please call us immediately
at (570) 546-9663 for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
Unpacking
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine. Discard immediately.
Tools Needed Qty
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Machinist's Square ............................................ 1
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 6. Loose item inventory.
A
C
E
F
H
G
D
B
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.