-70-
Model G0782 (Mfd. Since 10/15)
Machine Storage
To prevent the development of rust and corrosion,
the lathe must be properly prepared if it will be
stored for a long period of time. Doing this will
ensure the lathe remains in good condition for
later use.
Preparing Lathe for Storage
1. Run lathe and bring all reservoirs to operating
temperature, then drain and refill them with
clean oil.
2. Pump out old coolant, then add a few drops
of way oil and blow out the lines with com-
pressed air.
3. DISCONNECT MACHINE FROM POWER!
4. Thoroughly clean all unpainted, bare metal
surfaces, then apply a liberal coat of way oil,
heavy grease, or rust preventative. Take care
to ensure these surfaces are completely cov-
ered but that the rust preventative or grease
is kept off of painted surfaces.
5. Lubricate machine as outlined in Lubrication,
on
Page 63. Be sure to use an oil can to
purge all ball oilers and oil passages with
fresh oil.
6. Loosen or remove V-belts so they do not
become stretched during storage period.
Note: Be sure to place a maintenance note
near power button as a reminder that belts
have been loosened or removed.
7. Place a few moisture-absorbing desiccant
packs inside of electrical box.
8. Cover lathe and place it in a dry area that is
out of direct sunlight and away from hazard-
ous fumes, paint, solvents, or gas. Fumes
and sunlight can bleach or discolor paint.
9. Every few months, rotate by hand all gear-
driven components a few times in several
gear settings. This will keep bearings, bush-
ings, gears, and shafts well lubricated and
protected from corrosion—especially during
winter months.
10. Slide carriage, tailstock, and steady rest
down lathe bed to make sure that way spot-
ting is not beginning to occur.
Bringing Lathe Out of Storage
1. Re-install V-belts and re-tension them (refer
to
Page 79) if you removed them for storage
purposes.
2. Remove moisture-absorbing desiccant packs
from electrical box.
3. Repeat Test Run and Spindle Break-In pro-
cedures, beginning on
Page 24.
4. Add coolant, as described in Coolant System
Service on Page 68.
Summary of Contents for G0782
Page 116: ......
