-24-
Model G0776 (Mfd. Since 7/14)
Adding Coolant
Lubricating Lathe
GEARBOXES MUST
BE FILLED WITH OIL!
MACHINE MAY NOT BE
SHIPPED WITH OIL!
Requires Oil
Before Operation
or Warranty Will
Be Void.
The headstock, gearbox, and apron oil reservoirs
must have the proper amount of oil in them before
the lathe can be operated.
Damage caused to the bearings and gears from
running the lathe without oil in the reservoirs
will not be covered under warranty. Refer to the
Lubrication section, beginning on Page 66, for
checking and adding oil.
In addition to the reservoirs, we also recommend
that you lubricate all other points on the machine
at this time. To do this, follow the steps provided in
the maintenance schedule on
Page 65.
Note: If this lathe was shipped with oil in the res-
ervoirs, do not change that oil until after the
Test
Run and Spindle Break-In procedures.
Add the coolant of your choice now. For detailed
instructions on where the coolant tank is located
and how to add fluid, refer to
Coolant System
Service on Page 71.
Power Connection
Before the machine can be connected to the
power supply, there must be an electrical circuit
that meets the
Circuit Requirements for 220V
on
Page 16.
To minimize the risk of electrocution, fire, or equip-
ment damage, installation work and electrical wir-
ing MUST be done by an electrician or qualified
service personnel.
Note About Extension Cords: Using an incor-
rectly sized extension cord may decrease the
life of electrical components on your machine.
Refer to
Extension Cords on Page 17 for more
information.
Electrocution or fire
may occur if machine is
ungrounded, incorrectly
connected to power, or
connected to an undersized
circuit. Use an electrician
or a qualified service
personnel to ensure a safe
power connection.
