Model G0776 (Mfd. Since 7/14)
-19-
Figure 10. Mounted inventory components.
Figure 11. Loose inventory components.
H
F
I
G
E
A
B
C
D
Figure 12. Toolbox inventory.
L
K
R
Q
P
O
N
M
J
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Mounted Inventory Components
Qty
A. Three-Jaw Chuck 6" ................................... 1
B. Follow Rest ................................................. 1
C. Quick Change Tool Post w/Holder ............. 1
D . Steady Rest ................................................ 1
Loose Inventory Components
Qty
E. DRO Unit .................................................... 1
F. Toolbox ....................................................... 1
G. Four-Jaw Chuck 8" ..................................... 1
H. Four-Jaw Chuck Wrench ............................ 1
I. Faceplate Camlock Set .............................. 1
J. Faceplate 10" .............................................. 1
Toolbox Inventory Components
Qty
K. Spindle Sleeve MT#5/MT#3 ....................... 1
L. Dead Center MT#3 Carbide Tip ................. 1
M. Dead Center MT#3 HSS Tip ...................... 1
N. Tool Holder (One Installed) ........................ 2
O. Bottle for Oil ............................................... 1
P. Hex Wrench Set 3–6, 8, 10mm ............1 Ea.
Q. Phillips and Standard
Screwdriver #2 .....................................1 Ea.
R. Open-End Wrench Set
9/11, 10/12, 12/14mm ............................1 Ea.
S. Three-Jaw Chuck Key ................................ 1
T. Quick-Change Gear Set .......................1 Ea.
U. V-Belt A33 .................................................. 2
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
S
T
U
