Model G0764Z (Mfd. Since 10/15)
-77-
Test
Piece
1
2
3
4
Figure 158. Diagonals to measure on test piece.
Test
Piece
1
2
3
4
Figure 157. Fence adjustment test piece.
5. Use crosscut fence to cut
1
⁄
2
" off of each side
of test piece, then cut side 1 again (make five
cuts total).
6. Measure test piece diagonally from corner-to-
corner, as shown in
Figure 158.
— If both measurements are within
1
⁄
16
", then
you are finished with this procedure.
— If both measurements are not within
1
⁄
16
",
then crosscut fence needs to be adjusted.
Proceed to
Step 7.
7. Loosen crosscut fence pivot lock knob to
allow fence to pivot.
8. Loosen hex nut on the 0° stop bolt shown
in
Figure 156 on the previous page, rotate
0° stop bolt to square crosscut fence, then
retighten hex nut.
9. Move crosscut fence stop block against 0°
stop bolt, then retighten pivot lock knob to
secure fence in place.
10. Repeat Steps 5–6.
4. Prepare scrap test piece by cutting it to 32"
x 32" square, then number all four sides 1–4
(see
Figure 157).
Summary of Contents for G0764Z
Page 21: ...Model G0764Z Mfd Since 10 15 19 5mm Hardware Recognition Chart ...
Page 118: ......
