Grizzly G0751, Owner'S Manual

Page: 24 / 64

-22-
Model G0751 (Mfg. Since 1/13)
Headstock
Movement
the headstock travels up and down the column,
rotates around the column 180° in each direction,
and tilts 90° left and right relative to the table.
Raising/Lowering Headstock
Tool Needed Qty
Wrench 24mm ................................................... 1
Loosen the locking hex nuts shown in
Figure 12, then use the headstock z-axis crank
(see
Figure 13) to raise/lower the headstock.
Lock the headstock in place by retightening the
locking hex nuts before beginning operation to
avoid unexpected headstock movement.
Figure 12. headstock locking hex nuts.
Locking
hex nuts
Rotating Headstock
Tool Needed Qty
Wrench 24mm ................................................... 1
Loosen the locking hex nuts shown in
Figure 12,
then slowly rotate the headstock around the col-
umn. Lock the headstock in place by retightening
the locking hex nuts before beginning operation to
avoid unexpected headstock movement.
Tilting Headstock
Tool Needed Qty
Wrench 22mm ................................................... 1
Loosen the three tilt locking hex nuts—one on
each side of the headstock (see
Figure 14) and
one underneath the headstock (see Figure 15).
Figure 14. headstock tilt locking hex nuts.
Locking
hex nut
(1 on each side)
Figure 15. headstock tilt hex nut underneath.
Locking
hex nut
(Underneath)
slowly tilt the headstock to the desired angle, then
retighten the tilt locking hex nuts before beginning
operation to avoid unexpected headstock move-
ment.
Figure 13. headstock z-axis crank location.
headstock
z-axis
Crank