Grizzly G0751, Owner'S Manual

Page: 20 / 64

-18-
Model G0751 (Mfg. Since 1/13)
an arbor is included for the drill chuck that
comes with this machine. the following procedure
describes how to install the arbor in the chuck.
after the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. if you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
Important: DO NOT install the drill chuck and
arbor assembly into the spindle until AFTER the
test run.
To join the drill chuck and arbor:
1. Use acetone or lacquer thinner to clean drill
chuck and arbor mating surfaces, especially
the bore.
2. retract chuck jaws completely into chuck.
3. insert small end of arbor into chuck.
4. hold assembly by the arbor and tap chuck
onto a block of wood with medium force, as
illustrated in
Figure 10.
Joining Drill Chuck
& Arbor
Figure 10. tapping drill chuck/arbor on block of
wood.
5. attempt to separate drill chuck and arbor by
hand —if they separate, repeat
Steps 3–4.
GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
the headstock oil reservoir must be properly filled
with oil before the drill press can be operated for
the first time.
damage caused by running the machine without
the proper amount of oil in the reservoir will not be
covered under warranty. refer to the
Lubrication
section, beginning on
Page 31, for details on how
to check and add oil.
Lubricating Drill
Press