Model G0750GV (Mfd. Since 03/18)
-27-
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
To complete a typical operation, the operator
does the following:
1. Puts on safety glasses or face shield, rolls up
sleeves, removes jewelry, and secures any
clothing or hair that could get entangled in
moving parts.
2. Examines workpiece to make sure it is suit-
able for turning, then securely mounts it in
lathe.
3. For long pipes, rods, and shafts, installs
required safety anchoring support(s) and
steady/follow rests.
4. Installs tooling, aligns it with workpiece, then
backs it away from workpiece to establish a
safe startup clearance.
5. Removes all setup tools from lathe.
6. Checks for safe clearances by rotating
workpiece by hand at least one full revolution.
7. Moves apron, cross slide, and tool rests to
where they will be used during operation.
8. Sets correct spindle speed for operation, then
double-checks speed setting.
9. If using power feed, selects proper feed rate
for operation.
10. Resets Emergency Stop button, then starts
spindle rotation.
11. Uses carriage handwheels or power feed
options to move tooling into workpiece for
operation.
12. When finished cutting, moves spindle lever to
OFF position, then removes workpiece.
To reduce the risk of eye
injury from flying chips,
always wear safety glasses
or a face shield when oper-
ating lathe.
Summary of Contents for G0750GV
Page 116: ......
