Model G0725 (Mfd. Since 02/20)
-33-
Adjusting/Replacing
Belts
The Model G0725 uses belts to drive both the
cutterhead and the dust collection fan. When
these belts are misaligned, damaged, or not
tensioned correctly, the jointer will not function
properly.
This sub-section describes how to service these
belts. You can order replacement belts from
Grizzly. The part number for the drive belt is
P0725070; the part number for the fan belt is
P0725092.
Tools Needed
Qty
Phillips Head Screwdriver .................................. 1
Hex Wrench 6mm .............................................. 1
To re-align or replace cutterhead belt:
1. DISCONNECT MACHINE FROM POWER!
2. While facing the rear of the jointer, tip it away
from you until it rests on the fence assembly.
3. Remove the Phillips screws fastening the
motor cover to the jointer base. Lift the cover
off and set it aside.
4. Remove all dust and debris from the motor
and belt areas.
5. Inspect the cutterhead belt for proper tension,
alignment and condition.
Note: The belt is properly tensioned if it
deflects no more than
3
⁄
8
" when you press
down on middle of the belt with moderate
pressure from your thumb or forefinger.
The belt is properly aligned if it lies flat and
straight on the motor shaft and drive pulley.
Belt damage will be evident on inspection.
6. Loosen the four motor mounting cap screws
(see
Figure 43), but do not remove them.
This will release the belt tension.
7. Replace a damaged belt with a new one.
Realign and re-tension the belt by tightening
the four motor mounting cap screws.
8. Tighten the motor mounting cap screws and
replace the motor cover.
9. Test run the jointer. Repeat this procedure if
necessary. If repeating this procedure does
not solve the problem, call Grizzly Tech
Support.
To replace fan belt:
1. DISCONNECT MACHINE FROM POWER!
2. Remove the motor cover and check the belt
for damage.
—If the belt shows no wear or damage, pre-
cede to
Step 4.
3. Remove the belt. Put one end of the new belt
on the fan pulley, then fit the other end onto
the drive pulley.
Note: It is highly unlikely that this belt will
ever be misaligned or out of tension. If it is,
the jointer needs to be serviced by a qualified
technician. Call our Tech Support.
4. Re-install the motor cover.
Figure 43. Motor mounting screws and belt
locations.
Motor Mount Screws
Cutterhead Belt
Fan Belt
Summary of Contents for G0725
Page 44: ......
