Grizzly G0725, Owner'S Manual

Page: 17 / 44

Model G0725 (Mfd. Since 02/20)
-15-
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Mounting
Figure 9. Example of a "Through Mount" setup.
Figure 10. Example of a "Direct Mount" setup.
To assemble jointer:
1. Use (2) M8-1.25 x 20 cap screws and (2)
8mm lock washers to attach fence support to
jointer bed (see
Figure 11).
2. Insert locking plate assembly into fence sup-
port, positioning it so both pins are against
bottom edge of fence support (see
Figure 12).
Figure 12. Inserting the locking plate.
Locking
Plate Pins
Locking Plate
Assembly
Assembly
Figure 11. Attaching the fence support to the
bed assembly.
Cap Screws
x 2
Fence
Support
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).