Grizzly G0725, Owner'S Manual

Page: 20 / 44

-18-
Model G0725 (Mfd. Since 02/20)
5. Move the straightedge to position A, as
shown in Figure 21. Turn the jack screw
nearest the fence counter-clockwise
1
⁄
8
of a
turn until the end of the knife touches the
straightedge.
6. Move the straightedge to position B, as
shown in Figure 21. Turn the jack screw
nearest the guard counter-clockwise
1
⁄
8
of
a turn until the end of the knife touches the
straightedge.
7. Rotate the cutterhead slightly without disturb-
ing the knife clamp to check the knife height.
—If the knife moves the straight edge slightly
(
1
/
8
") forward and back on the table, the
knife height is set correctly.
—If the knife does not move the straightedge
slightly (
1
/
8
") forward and back on the table,
continue to make fine adjustments with the
jack screws until the knife is set correctly.
8. Repeat Steps 4–8 with the other cutterhead
knife.
9. When the knife height is set correctly, firmly
tighten each of the knife clamp screws.
Figure 21. Straightedge positions A and B.
Black Lines Represent
Straightedge Positions
From Overhead View
A
B
To Install dust collection chute and bag:
1. Install the dust chute by attaching the dust
chute to the chip exhaust and tighten the hex
nut.
2. Slip the bag clamp over the collection bag,
then attach the collection bag to the chute
and clamp it, as shown in
Figure 22.
Figure 22. Attaching the dust collection bag.
Bag
Clamp
Dust Collection
DO NOT operate the Model G0725 with-
out an adequate dust collection system.
This machine creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in short
and long-term respiratory illness.
Recommended CFM at Dust Port: 150 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
The Model G0725 has a built-in dust collection
fan and includes a dust collection bag. It can also
be hooked up to a pre-existing dust collection
system.