Grizzly G0715P, Owner'S Manual

Page: 72 / 88

-70-
Model G0715P (Mfg. 4/11+)
Miter Gauge
Adjustments
The miter gauge is equipped with stop screws that
allow you to easily adjust the miter gauge 0°– 30°
left, 90°, and 0°–45° right. The stop screws con-
tact the shaft, which moves in or out of the way
for adjustments.
Tools Needed Qty
Phillips Head Screwdriver .................................. 1
90° Square ........................................................ 1
45° Square ........................................................ 1
30° Square ........................................................ 1
Wrench 8mm ..................................................... 1
Checking/Setting 90° Stops
1. DISCONNECT SAW FROM POWER!
2. Slide the miter gauge into the T-slot on the
table.
3. Adjust the miter gauge so the 90° stop screw
rests against the sliding shaft.
4. Place the square evenly against the face of
the miter gauge and the blade, as shown in
Figure 117.
Figure 117. Checking 90° stop on miter gauge.
Square
Miter Gauge
Blade
— If the square touches the miter body and
the body of the blade (not the teeth) evenly
at the same time, then it is square to the
blade and the 90° stop is set correctly. No
further adjustments are necessary.
— If the square does not touch the miter body
and blade evenly at the same time, then
proceed to
Step 4.
5. Loosen the hex nut (jam nut) that secures the
90° stop screw (see Figure 118), and adjust
the stop screw until it is seated against the
shaft while the square is evenly touching the
miter body and the blade body, then tighten
the hex nut.
Checking/Setting 45° Stops
Follow the same process with the 45° and 30°
stops that you followed with the 90°, except using
a 45° and 30° square or adjustable square to
verify that the miter body is 45° to the blade, as
shown in.
Figure 118. Checking 45° stop on miter gauge.
6. Loosen the screw on the front of the miter
bar, adjust the pointer to 0°, then tighten the
screw.
Hex Nut
Sliding Shaft
90° Stop
Screw