Grizzly G0715P, Owner'S Manual

Page: 27 / 88

Model G0715P (Mfg. 4/11+)
-25-
Figure 25. Dust hose attached to dust port.
DO NOT operate the Model G0715P without
an adequate dust collection system. This
saw creates substantial amounts of wood
dust while operating. Failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Dust Collection
To connect a dust collection hose:
1. Fit a 4" dust hose over the dust port, as
shown in Figure 25, and tightly secure it in
place with a hose clamp.
2. Tug the hose to make sure it does not come
off. Note: A tight fit is necessary for proper
performance.
Components and Hardware Needed: Qty
Dust Hose 4 " (not included) ...............................1
Hose Clamps 4" (not included) ..........................2
Dust Collection System (not included) ...............1