Grizzly G0636X, Owner'S Manual, Page: 25 / 68

Model G0636X (Mfd. Since 09/18)
-23-
Test Run
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following: 1)
The motor powers up and runs correctly, 2) the
safety disabling mechanism on the switch works
correctly, and 3) the stop button safety feature
works correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 46.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run machine:
1. Make sure you have read safety instructions
at beginning of manual and that the machine
is set up properly.
2. Make sure all tools and objects used during
setup are cleared away from machine.
3. Connect machine to power source.
4. Verify machine is operating correctly by turn-
ing switch disabling key ( Figure 20) to "1"
and turning machine
ON.
—When operating correctly, machine runs
smoothly with little or no vibration or rub-
bing noises.
— Investigate and correct strange or unusu-
al noises or vibrations before operat-
ing machine further. Always disconnect
machine from power when investigating or
correcting potential problems.
5. Press OFF button to stop machine.
6. WITHOUT resetting OFF button, press ON
button. The machine should not start.
—If machine does not start, the OFF button
safety feature is working correctly.
—If machine does start (with stop button
pushed in), immediately disconnect power
to machine. The OFF button safety feature
is not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
7. Twist OFF button clockwise so it pops out.
When OFF button pops out, switch is reset
and ready for operation (see
Figure 21).
OFF Button
TWIST
Figure 21. Resetting the switch.
8. Turn switch disabling key to "0", as shown in
Figure 20.
Figure 20. Location of switch disabling key and
ON/OFF switch.
Key
On Button
Off Button