-24-
Model G0561 (Mfd. Since 01/08)
Vise
The vise can hold material up to six inches wide
and be set to cut angles from 0 to 45 degrees.
To square blade to vise:
1. Loosen lock nut shown in Figure 27 with
3
⁄
4
"
wrench or socket.
2. Use scale to set your angle.
3. Tighten lock nut.
4. Loosen lock nut in Figure 29 on opposite
jaw so jaw can float, and match angle of
workpiece.
To adjust angle on vise:
1. Loosen lock nut on rear jaw with a
3
⁄
4
" hex
wrench, as shown in
Figure 28.
Figure 27. Location of lock nut.
2. Use scale as a guide to set your angle, or a
machinist's square to square blade to vise.
3. Tighten lock nut.
Lock Nut
Figure 28. Location of scale.
Scale
Lock Nut
Figure 29. Vise jaw lock nut.
Lock Nut
5. Tighten vise against workpiece.
Summary of Contents for G0561
Page 60: ......
