Model G0490W/G0490XW (Mfd. Since 5/16)
-45-
3. Place straightedge in one of the positions
shown in
Figure 74, and adjust eccentric
bushings so straightedge touches cutterhead
body while lying flat across outfeed table (a
pin-type spanner wrench or small hammer
and punch may be necessary to turn eccen-
tric bushings).
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 74. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
4. Repeat Step 3 with each remaining straight-
edge position as many times as necessary
until outfeed table is parallel with cutterhead.
5. Tighten/replace set screws in eccentric bush-
ings on outfeed table.
6. Remove set screw from each of the four
eccentric bushings under infeed table.
7. Place straightedge halfway across infeed and
outfeed tables, and adjust infeed table even
with outfeed table, as shown in
Figure 75.
8. Place straightedge in one of the positions
shown in
Figure 76, and adjust eccentric
bushings under infeed table so straightedge
lies flat against both tables.
Straightedge
Outfeed Table
Infeed Table
Figure 75. Infeed and outfeed tables set evenly
(knife-style cutterhead shown).
9. Repeat Step 8 with each remaining straight-
edge position as many times as necessary
until infeed table is parallel with outfeed table.
10. Tighten/replace set screws in eccentric bush-
ings on infeed table.
11. Perform Setting Outfeed Table Height on
next page.
Black Lines Represent
Straightedge Positions
from Overhead View
Figure 76. Straightedge positions for checking
infeed/outfeed table parallelism.
Summary of Contents for G0490W
Page 64: ......
