Grizzly G0490W, Owner'S Manual

Page: 44 / 64

-42-
Model G0490W/G0490XW (Mfd. Since 5/16)
5. Place straightedge on outfeed table so it hangs
over cutterhead, then lower outfeed table
until straightedge just touches cutterhead
body.
6. Place straightedge in positions shown in
Figure 69. In each position, straightedge
should touch cutterhead and sit flat on outfeed
table.
Black Lines Represent
Straightedge Positions
From Overhead View
Figure 69. Straightedge positions for verifying if
outfeed table is parallel with cutterhead.
— If straightedge touches cutterhead body
and sits flat across outfeed table in each
position, then outfeed table is already par-
allel with cutterhead. Follow the
Checking
Infeed Table instructions on Page 43.
— If straightedge does not sit flat on outfeed
table and touch cutterhead and in any of
the positions, then outfeed table is not par-
allel with cutterhead. Perform
Adjusting
Table Parallelism procedure on Page
43, then perform Checking Infeed Table
instructions on
Page 43.
Checking/Adjusting
Table Parallelism
If the tables are not parallel with the cutterhead
and each other, then poor cutting results and kick-
back can occur.
Tools Needed Qty
Straightedge ...................................................... 1
Open-End Wrench 16mm .................................. 1
Hex Wrench 3mm .............................................. 1
4. Rotate motor pulley so that you can access
cutterhead body with straightedge between
the knives/inserts, as shown in
Figure 68.
Straightedge
Outfeed Table
Figure 68. Adjusting outfeed table even with
cutterhead body (knife-style cutterhead shown).
Figure 67. Outfeed table positive stop bolts.
Stop Bolts
Checking Outfeed Table
1. DISCONNECT MACHINE FROM POWER!
2. Remove cutterhead guard, fence, and cabi-
net rear access panel.
3. Loosen outfeed table lock located at front of
machine, and loosen jam nuts and positive
stop bolts located at back of machine just
behind outfeed table (see
Figure 67).
Jam Nuts