5.1 Master -Slave
More KOLORSTREAM units can be set to ‘SLAVE’ to follow the ‘MASTER’ unit in synchrony.
The ‘MASTER’ unit must be set to MASTER ON, the ‘SLAVE’ units must be set to ‘MASTER
OFF’ (with address number 1 and options 2,3 and 4 set to off).
Master Slave Slave Slave
Master On Master Off Master Off Master Off
(1.ON) (1.OF) (1.OF) (1.OF)
The line terminal is a resistor fitted between the 2 Signal Pins (2 and 3) at the end of the DMX.
line. This is to avoid the defective functioning of the DMX line. A 120 Ohm resistor is suggested.
KOLORSTREAM can also operate on ‘SLAVE’ mode when the ‘MASTER’ unit is a Kolorado
MK2 1800 or a Kolorado MK2 2500. In this contest the zoom channel (N°6) will be automatically
set to value 0 which corresponds to the narrowest beam projection. It is anyway suggested to set
the KOLORSTREAM unit as the ‘MASTER’ of the chain.
6.0 MAINTENANCE
All lanterns require regular maintenance to ensure maximum performance and light output.
Please follow these instructions:
- clean, mirrors and dichroics regularly, as even a thin layer of dust can reduce the light output and
scatter the beam;
- replace the lamp in case it is damaged or deformed;
- carefully check the electrical connections, particularly the earth connection;
- replace the lenses, the mirrors and the dichroic filters if they are visibly damaged;
- replace all the damaged components
IMPORTANT: clean regularly the fans and the grids. Don't use screw drivers or sharp objects
which may damage the fans or other parts of the lantern. The grids can be removed by unscrewing
the 4 self-tapping screws.
Line terminal
17
