Griven KALEIDO GR 0410 MSD 575 W, Instructions Manual

Page: 10 / 20

1.0 PACKING
Check carefully the content of the box and in case of damage contact your forwarder immediately.
The following items are included in the box:
n° 1 instructions leaflet;
n° 1 KALEIDO unit;
n° 2 XLR 3 poles plugs (1 male + 1 female);
2.0 SAFETY
Disconnect the lantern from mains supply before servicing the unit or replacing the lamp.
- This projector has been designed for outdoor and indoor use. For safety operation, maximum
ambient temperature must not exceed 40°C.
- Caution: the temperature of the glass surface of the projector can reach 130°C
- Caution: hot lamp; ensure that the lamp is cold before attempting to remove it (wait for about 20
minutes).
- Caution: it is strongly recommended that a safety-chain or wire is attached to this projector and
secured to the main mounting framework to arrest the fall of the unit in the unlikely event that the
primary mounting arrangement should fail.
3.0 INSTALLATION
3.1 Fitting the lamp
1) Open the glass cover untightening the 6 screws located on the top part of the lantern (Pict. 1).
2) Clean the lamp with a cleaning towel and fit it carefully in the lamp holder.
- avoid touching the lamp with fingers or dirty towels;
- do not shake the lamp;
- position the lamp towards the lamp cover to obtain the maximum light output
3) Tighten the fixing knobs to fix the lamp to the lamp holder.
5) Put the glass cover in its original position.
6) Fix the glass cover with the 4 screws again.
Please remove the reflecting aluminium cover by unscrewing the metal knob as per picture 2.
4.0
10
Pict. 1
Pict. 2