Frankenrunner User Manual
Rev 1.0
with an (optional) PAS or Torque sensor hooked up to the 6 pin PAS plug as
well.
All the key control signals (throttle, ebrake, PAS/Torque) go directly to the
Frankenrunner
and not the display, so additional controller parameters must be
set up to achieve desired control response. The display has the on/off power
control and up/down settings to set the assist level, but otherwise plays a passive
role in the actual system behavior.
In this wiring approach, the WP8 Cycle Analyst plug is not needed, but it can be
used as a convenient tap point to power a rear bike light as well.
At present Grin only provides support for this third-party display hookup to OEM
customers, and does not offer support or the components for this at the retail
level. Configuration and additional controller settings will be detailed in a
separate document to this manual.
3.3 Headless System
Finally, the
Frankenrunner
can be run with only a throttle on the Mains plug, or a
PAS / Torque sensor plugged into the 6 pin PAS plug. In these arrangements, it
is essential to wire up the on/off power switch on either the WP8 plug or the
Mains connector for the controller to turn on.
-6-
