Frankenrunner User Manual
Rev 1.0
2 Connectors
The controller has been connectorized to achieve maximum versatility with
minimal wiring, using a combination of waterproof overmolded ebike plugs for
signals and popular compact connectors for high current.
2.1 Battery Power
DC Power Pinout
The embedded plug on the back of the device provides a
reliable hookup to DC battery power through the compact
and popular XT60 plug interface.
A 30cm XT60 to Anderson cable is provided with each
device to match the Anderson standard used on many
ebike batteries.
- Warning – The controller may suffer irreparable damage if leads are hooked up in reverse
polarity. Always check the polarity of the connector before applying power.
2.2 Motor Cable – L10 Model
The L10 model has a 40cm lead to a Higo L1019 connector for direct hookup to a
compatible motor. This length is sufficient to reach a rear hub motor with the
controller mounted on the seat-tube, or to a front hub motor with the controller on
the stem. Both 60cm and 100cm L10 extension cables are available when
longer lengths are required.
L10 Motor Plug Pinout
The Higo L1019 cable has three
motor phase pins capable of 80
amps peak, along with 7 small
signal wires for Hall position, speed
encoder, and motor temperature.
-2-
