16
COMMISSIONING REMOTE TRANSMITTERS (CONT.)
LIMIT SETUP WITH A REMOTE TRANSMITTER
To set the limits using a remote transmitter, first you will need a 3-button transmitter that has been programmed for OPEN, CLOSE, and
STOP. Refer to the Programming section.
INITIAL LIMITS AND FORCE ADJUSTMENT
The door MUST be attached to the operator before setting the limits and force.
Ensure the door is closed.
1. Press and release the SET OPEN and SET CLOSE buttons simultaneously to enter limit setting mode.
2. Press and hold the OPEN or CLOSE button on the remote transmitter until the door reaches the desired open position. The door can
be jogged back and forth using the OPEN and CLOSE buttons on the remote transmitter.
3. Once the gate/door is in the desired open position, press and release the STOP button on the remote transmitter.
4. Press and release the OPEN button on the remote transmitter again to set the open limit.
5. Press and hold the CLOSE or OPEN button on the remote transmitter until the door reaches the desired close position. The door can
be jogged back and forth using the OPEN and CLOSE buttons on the remote transmitter.
6. Once the door is in the desired close position, press and release the STOP button on the remote transmitter.
7. Press and release the CLOSE button on the remote transmitter again to set the close limit.
8. Cycle the door open and close. This automatically sets the force. When limits are set properly the operator will automatically exit limit
setting mode.
ADJUST THE LIMITS
(if needed)
If the limits have already been set the operator will exit the limit setting mode after resetting each limit.
SET THE CLOSE LIMIT ONLY
1. Press and release the SET OPEN and SET CLOSE buttons simultaneously to enter limit setting mode.
2. Press and hold the CLOSE button on the remote transmitter until the door reaches the desired close position. The Door can be jogged
back and forth using the OPEN and CLOSE buttons on the transmitter.
3. Once the door is in the desired close position, press and release the STOP button on the remote transmitter.
4. Press and release the CLOSE button on the remote transmitter again to set the close limit.
When the close limit is set properly the operator will automatically exit limit setting mode.
SET THE OPEN LIMIT ONLY
1. Press and release the SET OPEN and SET CLOSE buttons
simultaneously to enter limit setting mode.
2. Press and hold the OPEN button on the remote transmitter until the
door reaches the desired open position. The door can be jogged
back and forth using the OPEN and CLOSE buttons on the
transmitter.
3. Once the gate/door is in the desired open position, press and
release the STOP button on the transmitter.
4. Press and release the OPEN button on the transmitter again to set the open limit.
When the open limit is set properly the operator will automatically exit limit setting mode.
DIAGNOSTICS
3-Button Transmitter programmed for
OPEN, CLOSE and STOP
COMMISSIONING
