11
Part No.
GLCPS
Description
Grifco Light Curtain Protector System - plug-in monitored send/receive light
curtain (Inc light curtains, mount system & cable)
MONITORED LIGHT CURTAIN
The Grifco Light Curtain offers the ultimate in superior safety. Regardless of
the application, the multiple angled light beams create a ield of entrapment
protection ensuring unsupervised closing doors operate in a safe manner.
Part No.
GPS15
Plug-in monitored Relective Beam
For door widths up to 15m
MONITORED REFLECTIVE SAFETY BEAM KIT
When utilised as part of a Monitored Entrapment Protection System, these
beams offer exceptional safety for auto-closing doors. If an obstruction is
detected the door will stop and reverse. The relective beam requires wiring to
only one side of the door opening.
Part No.
GPS772
Plug-in monitored Send / Receive Beam
For door widths up to 15m
MONITORED SEND / RECEIVE SAFETY BEAM KIT
Send / Receive beams are ideal for emergency services facilities. Wiring is
required down both sides of the door opening.
Part No.
BMSE30K
(other lengths
available)
Wired safety edge 3,000mm
MONITORED SAFETY EDGE
Safety edge is mounted to the bottom of the door and detects obstructions
upon contact.
A monitored safety device requires a dedicated control system to
actively supervise the state of the safety sensor to ensure that any
kind of sensor failure will be detected, preventing the door from
operating unsafely. Non-compliant safety sensors, relying on a
non-monitored, normally-closed contact, can be bypassed or
fail to operate in the event of damage or tampering. Entrapment
Protection Systems must be monitored to form part of a compliant
system.
This operator provides a range of open and close automation options
and therefore entrapment protection devices must be itted to ensure
compliance to the relevant standard (AS/NZS 60335-2-103).
Methods used to provide safety and compliance are determined by
the functional requirements of the installation and the door type. It is
the responsibility of the installer to ensure the installation meets the
requirements of AS/NZS 60335-2-103.
GRIFCO offers a range of entrapment protection devices including
Safety Beams, Light Curtains, and Safety Edges. An example sectional
door installation using GRIFCO entrapment protection devices is shown
right.
TYPES OF MONITORED ENTRAPMENT PROTECTION
SELECTION OF ENTRAPMENT PROTECTION SYSTEM
COMMISSIONING
Safety Beam 80-90mm from ground
(GPS15 / GPS772)
Safety Edge (BMSE30K)
NOTE: Where a grill type door is installed with openings ≥50mm protection in the opening direction is required. This can be
achieved with the installation of a monitored safety beam mounted on the outside of the door to protect against entrapment
protection / collision with the door lintel. GRIFCO monitored Safety Beams must be used to provide protection.
For applications with no monitored entrapment protection, the operator can be controlled using the on-board "OPEN /
CLOSE / STOP" inputs with the use of a hold-to-close push button accessory. See page 18 for installation instructions.
