10
The door MUST be attached to the operator before setting the limits
and force.
1. Press and release the SET OPEN and SET CLOSE buttons
simultaneously to enter limit setting mode
2. Press and hold one of the MOVE GATE buttons to move the
door to the open or close limit
3. Press and release the SET CLOSE or SET OPEN button
depending on which limit is being set
4. Press and hold one of the MOVE GATE button to move the door
to the other limit
5. Press and release the SET CLOSE or SET OPEN button
depending on which limit is being set
6. Cycle the door open and close by pressing the green "TEST
BUTTONS" (Open and Close). This automatically sets the force
When limits are set properly the operator will automatically exit limit
setting mode.
INTRODUCTION
Your operator is designed with electronic controls to make travel
limit and force adjustments easy. The adjustments allow you to
program where the door will stop in the open and close position.
The electronic controls sense the amount of force required to open
and close the door.
The force is adjusted automatically when you program the limits but
can be fine tuned using the REVERSAL FORCE dial on the control
board (refer to Fine Tune the Force section) to compensate for
environmental changes.
The limit setup LEDs (located next to the SET OPEN and SET
CLOSE buttons) indicate the status of the limits, refer to
the table below.
LIMIT SETTING
LIMIT SETUP LEDS
SET OPEN
LED
SET CLOSE
LED
OPERATOR MODE
EXPLANATION
OFF
OFF
NORMAL MODE
Limits are set
BLINKING
BLINKING
LIMIT SETTING MODE
Limits are not set
BLINKING
ON
LIMIT SETTING MODE
Open limit is not set
ON
BLINKING
LIMIT SETTING MODE
Close limit is not set
ON
ON
LIMIT SETTING MODE
Limits are set
DIAGNOSTICS
DIAGNOSTICS
1
2
3
4
5
WARNING
• NEVER increase force beyond minimum amount required to
move door.
• NEVER use force adjustments to compensate for a binding or
sticking door.
• If one control (force or travel limits) is adjusted, the other control
may also need adjustment.
The limits can be set using the control board (below) or a remote transmitter (refer to Limit Setup with a Remote Transmitter in the
Programming section). Setting the limits with a remote transmitter requires a 3-button transmitter programmed to OPEN, CLOSE, and STOP.
NOTE: The Test Buttons on the control board will not work until the limits have been set.
COMMISSIONING
