T02.0.3X.6C-07
Mounting and operating manual OXY 3610 MP
Page 4 von 14
1.5 Reasonably foreseeable misuse
This device must not be used at potentially explosive areas!
Do not use these products as safety or emergency stop devices or in any other application
where failure of the product could result in personal injury or material damage.
Failure to comply with these instructions could result in death or serious injury and material dam-
age.
This device must not be used at a patient for diagnostic or other medical
purpose
1.6 Suitability
This device has been designed and tested in accordance with the safety regulations for electronic devices. However,
its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures and special safety
advises given in this manual will be adhered to when using the device.
1.6.1
During configuration
Caution, acid!
The electrode contains KOH
KOH can cause severe chemical burns!
If there was contact:
• To skin: Flush contacted area with large amounts of water for several minutes.
• To clothing: remove contaminated clothing.
• To eyes: Flush with large amounts of water for at least 15 minutes, obtain medical treatment.
After swallowing:
• Give large volumes of water. DO NOT induce vomiting!
• Obtain medical treatment.
General instructions and safety regulations for electric, light and heavy current plants, including
domestic safety regulations (e.g. VDE), have to be observed.
Trouble-free operation and reliability of the device can only be guaranteed if the device is not
subjected to any other climatic conditions than those stated under "Specification". If the device is
transported from a cold to a warm environment condensation may cause in a failure of the func-
tion. In such a case make sure the device temperature has adjusted to the ambient temperature
before trying a new start-up.
This device only serves as supervision by the monitoring of essential or other for the customer
important systems.
It must not be used instead of compulsory approval monitoring devices and it is not designed for
that purpose. If this device is used for the monitoring of such systems on its own, the manufac-
turer will not assume liability for damages whatsoever.
