Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
9
E6CCXLX Battery-powered Tool
Operation—Cutting
Electric shock hazard:
This tool is not insulated. When using
this unit on or near energized electri-
cal lines, use proper personal protec-
tive equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Setup
1. Open the tool head.
2. Remove any accessories from the tool head.
3. Select the appropriate set of blades, using the
table provided on this page.
4. Install one blade in each groove. If the blades have
W-type tabs, lock them in place with the W-type
detents.
Important:
W-type dies must be locked into place
or the die detents will be damaged.
5. Visually check the blades to ensure that they are
aligned correctly so that they will complete the
butting operation.
6. Close the tool head.
Accessory Table
Task
Blade
Copper and aluminum
26 mm (1.00") max.
UC26
Copper and aluminum
40 mm (1.56") max.
UC40
ACSR
Copperweld
ACAR
Guy strand
EHS guy strand
Ground rod
Anchor rod
Soft bolts
Rebar
UCACSR
Threaded rod
Threaded rod
W-type Detents:
Press and slide the
adapter and/or die
into place.
Release to lock.
Important:
W-type dies must be locked into
place or the die detents will be damaged.
Cutting Procedure
1. Press the latch and open the tool head.
2. Position the item to be cut in the tool head.
3. Close the tool head.
4. Pull the trigger to cut the item.
5. Release the trigger when the cut is complete.
6. The ram returns automatically.
