Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
7
E6CCXLX Battery-powered Tool
Operation—Crimping
Setup
1. Open the tool head.
2. Remove any accessories from the tool head.
3. Select the appropriate set of dies. Use the
table provided below to select the corresponding
adapter set.
4. Install the adapters and dies—one set in each
groove. If either the adapters or dies have W-type
tabs, lock them in place with the W-type detents.
Important:
W-type dies must be locked into place
or the die detents will be damaged.
5. Visually check the dies to ensure that they are
aligned correctly so that they will complete the
crimping operation.
6. Close the tool head.
Accessory Table
Dies
Adapter Set
Greenlee K22, KA22, KC22-type
UA22
Greenlee W-type
UAW
Kearney “OD”
UAK
Thomas & Betts “6TON”
UAK
D3 Profile
UAW
Blackburn® “O”
UAK
Huskie “HT”
UAK
FCI Burndy “W”
UAW
Huskie “HT-58”
UAW
ILSCO “ND-60”
UAW
Izumi “N58”
UAW
Panduit “CD-2001”
UAW
W-type
W-type Detents: Press
and slide the adapter
and/or die into place.
Release to lock.
K22-type
Kearney
Important:
W-type dies
must be locked into
place or the die detents
will be damaged.
Preparing the Cable
Follow the lug manufacturer’s instructions for appropri-
ate cable strip length.
Crimping Direction
(evenly spaced)
First Compression
Crimping Direction
SIDE A
(evenly spaced)
Crimping Direction
SIDE B
(evenly spaced)
First Compression
SIDE A
First Compression
SIDE B
