Greenlee DM-65, Instruction Manual

Page: 7 / 72

DM-65
7
Using the Features
• RANGE: Press once to enter the manual ranging mode. “AUTO” will disappear from the display.
Press repeatedly to step through the ranges. Press and hold to return to the automatic ranging mode.
•
Hz %:
Press momentarily to toggle between frequency and duty cycle functions. This button is active
only when the selector is set to Hz/% .
• REL: Finds the difference between two measurements. While taking a measurement, press REL to
set the display to zero. “∆” will appear on the display. Take the second measurement. The value on
the display will be the difference between the two measurements. Press again to exit this mode.
• HOLD: Press momentarily to hold the present value on the display. Press again to exit this mode.
• : Press and hold until backlight illuminates. Press and hold again to turn off.
• : Press momentarily to toggle between functions.
• Automatic Power Off: To extend battery life, the meter will shut itself off after approximately
15 minutes of inactivity. To restore power, press any button or turn the selector to
OFF
and then back
on. To disable this feature, press any button while turning the meter on.
Using the Test Leads
Electric shock hazard:
The test leads supplied with this product comply with IEC 61010-031:2008, UL 61010-031:2010 and
CAN/CSA-C22.2 NO. 61010-031A-07–Amendment 1:2010. These safety standards limit the exposed
length of the probe tip to 4 mm for measurement categories III and IV. These test leads include a cap
that must be in place when used in measurement category III or IV applications.
Failure to observe this warning could result in severe injury or death.
CAT IV 600V
CAT III 1000V
CAT II 1000V
CAT IV 600V
CAT III 1000V
Cap can be removed for measurement category I or II applications.
Cap must be in place for
measurement category III
or IV applications.