![background image](http://html1.mh-extra.com/html/greencut/ebw700/ebw700_instruction-manual_2261529064.webp)
64
MACHINE CLAMPING AND GUIDING
This machine has been designed to be placed on the user’s back as if it were a backpack.
To install the machine on the back, pass the arms between the straps and place the machine on the back so that it
is well positioned and with the blowing tube on the right side and so that the throttle controls can be used with the
left hand.
While you work, hold the fumigator firmly with one hand on the handle.
WORKING WITH THE FUMIGATOR
Configure the machine as appropriate to the product to be used (liquid or powder).
INSERT THE PRODUCT INTO THE TANK
1. Close the clamp fluid tap or set the powder quantity lever to the minimum (lever next to throttle lever).
2. Insert the product to be fumigated into the tank and close it.
NOTE:
We recommend that you do not fill the tank with a lot of powder as engine vibrations can
cause it to clump.
REGULATE THE FLOW RATE OF THE PRODUCT TO BE FUMIGATED:
1. The flow rate of the liquid to be fumigated is regulated on the nozzle wheel. The liquid flow rates of each
position (from 1 to 4) are approximately those indicated in the attached table.
2. The powder flow is regulated by the lever next to the throttle lever. Minimum flow down, maximum flow up.
Start the machine and place it on your back. Adjust the desired speed and direct the flow to the fumigated area.
NOTE:
We recommend working early in the morning or late in the afternoon as the temperature is
lower and evaporation is reduced improving the effect of the fumigation product.
1
1
1
1
2
MAX.
MIN.
Summary of Contents for EBW700
Page 2: ......
Page 88: ...www greencut es Manual revisado en noviembre de 2018...