Green Machine GM15520, Operator'S Manual

Page: 15 / 40

11 — English

Put a few firm strokes on every tooth. File all left hand
cutters in one direction. Then move to the other side and
file the right hand cutters in the opposite direction. Oc-
casionally remove filings from the file with a wire brush.
CAUTION:
Dull or improperly sharpened chain can cause excessive
engine speed during cutting, which may result in severe
engine damage.
ATTACHING THE STORAGE HANGER
See Figure 24.
There are two ways to hang the attachment for storage.

To use the hanger cap, push in the button and place the
hanger cap over the end of the attachment shaft. Slightly
rotate the cap from side to side until the button locks into
place.
 The secondary hole in the attachment shaft can be used
for hanging purposes as well.
STORING THE ATTACHMENT

Clean the attachment thoroughly and lubricate before
storing.

Store the attachment indoors in a dry, well-ventilated
place that is inaccessible to children.

Keep away from corrosive agents such as garden chemi-
cals and de-icing salts.

Always place the scabbard on the cutting blade before
storing or when the attachment is not in use.
MAINTENANCE
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.
PROBLEM CAUSE REMEDY
Bar and chain running hot and
smoking. Check chain tension for overtight con-
dition.
Chain oil tank empty.
Tension chain. Refer to
Chain Tension
earlier in this manual.
Check oil tank.
Engine starts and runs, but chain is
not rotating. Chain tension too tight.
Check guide bar and chain assembly.
Check guide bar and chain for
damage.
Retension chain, Refer to Chain Tension
earlier in this manual.
Refer to Replacing the Bar and Chain
earlier in this manual.
Inspect guide bar and chain for damage.