Gree U-MATCH IV SERIES, Service Manual

Page: 41 / 164

38
U-Match Series DC
Inverter Service Manual
DPOUSPM
Figure 2-7-7
Note: You can purchase the accessory from Gree. The information is as below:
Name Product code Remark
Controller for door control function (MK03) MC207022 One controller for one unit
7.2.2 Human sensitive function
You can purchase the module of human sensitive function for this series. An interface for this module is
reserved on the mainboard of indoor unit.
(1). Interface instruction:
1). The printing is CN23 and the interface type is JST B3B-PH-K-S;
2). Electrical characteristic: 1-pin: +12V; 2-pin: detection port; 3-pin: GND; current: 150mA;
3). Working principle: when the module detects there is nobody in the room, 2-pin and 3-pin are short-
circuited and they are low electrical level; when there are somebody in the room, 2-pin output is high electrical
level.
(2). Function instructions:
In order to achieve this function, set it through wired controller and refer to the following operation method.
It is defaulted that this function is not activated; if this function is set and human sensitive module is connected,
the unit will control the ON/OFF of unit according to the signal detected by human sensitive module. When
there is nobody in the room and the unit is with wired controller,
icon will be displayed on the wired controller;
if the unit is without wired controller, there will be no display. The unit will control the ON/OFF of unit according
to the detected information.
(3). Setting method:
Under off state of the unit, press Function and Timer buttons at the same time for 5s to go to the debugging
PHQX3UHVV0RGHEXWWRQWRDGMXVWWR³´LQWHPSHUDWXUHGLVSOD\LQJ]RQH7LPHU]RQHGLVSOD\VVHWWLQJVWDWH
DQGSUHVVŸRUźEXWWRQWRDGMXVW7KHUHDUHVHOHFWLRQV
1). Without human sensitive function (LCD displays 00)
2). With human sensitive function (LCD displays 01)
Choose the second selection and then press Enter/Cancel button to save and exit setting. Now, human
sensitive function is activated. The unit will memorize this setting status. The setting value will be memorized
after power failure. The detailed setting is as shown in the Figure below: